N3vrSat1sfied
Military Member
- Location
- Fort Worth, TX
Q8 builders: I am running a Jet Maniac 781 with a 145 Skat Mag pump, any recommendations on Impeller size?
Thanks
Thanks
Custom/Hybrid Q8 Builders: 145 Mag Impeller?
- Thread starter N3vrSat1sfied
- Start date
- Location
- Northwest, CT
I was running a kawi 850 with tl . B pipe and 48's . Can keep listing Everything else if need but I had a 11/18 thin blade with -5 cutback, stubby cone and nozzle bored to 86mm. . Hooked like a mofo! I think it was a bit over propped bc when i put the medium tail cone . It really hurt the ski overall. Maybe a 10/18 hope that helps
N3vrSat1sfied
Military Member
- Location
- Fort Worth, TX
I found a deal on a used pump set up with a 5/13, is that way to low?
- Location
- Northwest, CT
I dunno what someone would use a 5/13 for
N3vrSat1sfied
Military Member
- Location
- Fort Worth, TX
Said it was behind a dasa 850 but wasn't too sure if on the pitch, he thought it was a 5/13
- Location
- Pennellville, NY
It was probable a 9/17.
I agree with the 9/17...its what the 750sx guys run generally. Are you going setback?
What nozzle gave you that monster bore?
N3vrSat1sfied
Military Member
- Location
- Fort Worth, TX
Last edited:
N3vrSat1sfied
Military Member
- Location
- Fort Worth, TX
Called Skat they recommended a 9/17 or 10/18 with an 86mm nozzle.
swannysxr
Site Supporter
- Location
- Lake orion, MI
does that pump have trim?
- Location
- Northwest, CT
skat trim system
N3vrSat1sfied
Military Member
- Location
- Fort Worth, TX
I found a used one with modded EME skat trim (pending purchase). So I will just have to send the impeller to Skat to get repitched to either the 9/17 or 10/18