onesojourner
I use a thumb throttle.
- Location
- springfield, mo
Can some one give me some tips on getting my old pump bearings off and getting my new bearings one?
I am doing my midshaft to.
I am doing my midshaft to.
Removing pump bearings
- Thread starter onesojourner
- Start date
- Location
- New York Crew
A bullet heater to the pump for about 3-5 mins, then tap it out with a few blocks o wood under the pump. Make sure to use a dead blow hammer or another pc o wood so you dont damage the splines. Mine dropped right out.
Here is the post on the reinstall, I heated it and poped em right back in the same way.
http://www.x-h2o.com/threads/72775
Here is the post on the reinstall, I heated it and poped em right back in the same way.
http://www.x-h2o.com/threads/72775
Last edited:
- Location
- savannah/hilton head
if you have access to a press that will make quick work of it also. no heat needed.
- Location
- Reno,NV
press is the way to go.....check harbor freight
- Location
- Texas
I want to get a press so badly, think I might jump in a few months... It will be awesome, Harbor Freight is awesome too.
Ejake
straight cash homie
- Location
- Nixa, Mo & LOTO 43mm
I've got a brand new set of barrings your welcome to have. Lol. Let me know when you wanna meet up.
Midlake Crisis
Site Supporter
- Location
- Bakersfield, CA
A used "bearing buddy" from your trailer is just the right size to press out the midshaft bearing with -
