Other removing tray after defoam?

ok so I made my cuts to take the whole tray out in one piece and im sure I cut all the way through, but is there a trick to getting it out actually?
Its stuck to the foam underneith and sounds like im going to snap the side of the tray in half taking it out

any tips?
 

Big Kahuna

Administrator
Location
Tuscaloosa, AL
use a thin object like a hack saw blade and cut the foam from the underside, you can also slowly insert some wedges and apply pressure to the underside and increase the wedge slowly, it will cause it to slowly break bond.
 

tokarzl

itching my arms
there is adhesive above the pump area and on the rear bondline be carefull not to force anything out cutting around that area would be easiest so that its just the foam holding the tray down
 

Mark44

Katie's Boss
Location
100% one place
Why are you cutting the entire tray out? You only need a few access holes. In front of the pump roughly 10X10 and one on eack side of the pump area.

Mark44
 
Why are you cutting the entire tray out? You only need a few access holes. In front of the pump roughly 10X10 and one on eack side of the pump area.

Mark44

Im also shortening the hull, modding my footholds a good bit, and widening the tray so itll just be easier this way
 
Top Bottom