RRP carbon tube into billet lite - engagement

[MTRHEAD]

What is the minimum engagement of the RRP carb tubes into the billet lite pole? Some reference point like end of 3rd bolt or 1/2 beyond. Something like that

the instructions don’t address! RRP pole instructions are weak! I even got some bolts and spacers I have no idea what they are for
The tubes pushed all the way in makes the length about same as OEM 2008 pole. (pivot bolt to steering pivot)
Way to short with OVP. That takes off about 4” from an oem setup. I looked around and longer than 26” tubes are not available.

 

[Ducky]

@Aquaholic would know this.

 

[Big Kahuna]

You should still have the sight windows that shows the minimum insertion points....

 

[MTRHEAD]

You should still have the sight windows that shows the minimum insertion points....

Billet lightweight doesn’t. I estimated based on normal pole

 

[Big Kahuna]

Ok. When you said billet, I thought you had full bullet liteweight pole, not the carbon version..

 

[MTRHEAD]

I wish they sold 28 or 30” tubes for racers. With OVP it’s short!!!

 

[Aquaholic]

At the end of the 3rd bolt (top). You're good, right where you are.

 

[MTRHEAD]

At the end of the 3rd bolt (top). You're good, right where you are.

What about on bottom? Flush with bottom bolt? Pics from normal pole look lower

 

[JKMike]

Check out this video from TC Freeride. It goes through the full install. But if you just start at 17:00 there are some good shots of where he has them and it's further than I expected.

Here is a screenshot too.

 

[MTRHEAD]

Does show much on the bottom. I can’t image an 08’ with OVP and 24” tubes.