- Location
- Milton, Florida
For those with rrp (or powerfactor) exhaust: How on earth do you tighten the two bolts in the middle at the bottom of the manifold? Very hard to fit any wrench in there.
RRP Exhaust Bottom-Middle Bolts
- Thread starter fischer550
- Start date
- Location
- Milton, Florida
What?
This Pittsburgh box 12 mm fits once most of the way in on the rrp. Seemed tighter on Pf though. On both I used this snap on 4 way offset wrench. 12mm headed bolt though, pre started most of the way, just enough out to roll/slide the manifold on.., then fight it with this wrench lol. I remember useing a finger and the tip of a screw driver to try and twist the bolt too before wrench time
With starter out you can get some room at the bottom to access it but I don't.
With starter out you can get some room at the bottom to access it but I don't.
12mm Bluetooth wrench lol
Pull your starter you’ll have a way better time. I use a shorty snap on ratchet wrench
- Location
- Milton, Florida
Can you post a link? Can't find a "bluetooth wrench" online
Lol you could try a WiFi one too
- Location
- Milton, Florida
Comedian over here haha
I couldn’t help myself
I have a variety of shaved and cut 12 and 13 mm end wrenches that are different angles. Apparently arp has a 8x1.25 bolt with a 10mm head but I havnt looked to hard for it.
Lol 12 seconds on google http://www.jegs.com/i/ARP/070/761-1..._Q3T5YIDecguGVnDaPmUIH-ZtUhEwMV4aAm8xEALw_wcB
- Location
- Valley Springs, CA
I run titanium race drilled on the two inner ex manifold bolts and they conveniently have a 10mm head
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
- Location
- Boise, Idaho
My patience and knuckles..and wrench set thank you for this info.
- Location
- South Africa
Remove starter and engine mount bracket, all the space you need
