Thx guys knew something was up, I ended up sanding the ends down so it would fit, got one side lined up where it needs to b, but the other side won't line up I've hit it with a rubber mallet all I'm going to probably have to cut spacer and get new one, dnt wanna break this base before I get to use it
There ARE two sizes of pole bolt spacers (ie the aluminum tube for running a tight pole instead of a spring), one for bilet poles and one for cast poles. I remember having this discussion when I was ordering stuff from Thrust. I ended up with a red one because it was the only billet sized one they had in stock and I was in a hurry.
I also think that there are different bushings (the hard rubber/plastic ones) because the thin ones I got were too thin and the thick ones too thick, had to shave them down with a flap disk on an angle grinder.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.