Custom/Hybrid Seeking Help With Aftermarket Trim Cable Attachments (WDK ROK-R)

[red_ak_ranger]

2013 ROK-R. See attached Photos which are brand new x-scream trim cable with finger throttle and old attachment.
.
Previous trim cable (that has seized) had a "janky attachment" to the finger throttle. So I believe I need to buy THIS replacement throttle which is same company as the trim cable i purchased?

Trim Lever - $34.95 : Team Xscream, The Worldwide Provider of Everything Freestyle & Freeride

Team Xscream Trim Lever - This is the same high quality lever used with the XScream Trim System.

www.teamxscream.com

.
Opposite end of trim cable, the old cable ran through that eyelet with a threaded end piece, and you would attach a nut each side it in place. new cable doesn't have the threaded section. What do I replace this threaded eye with to fix this? See "IMG-1823" - I was recommended to buy the red piece but am unaware of what it's called our how to find it.
.
Appreciate yall's help in this.

 

[Roseand]

Buy the red cable holder straight from xscream. Use any bike brake lever but you'll need to drill out the cable adjuster to fit the trim cable

 

[Roseand]

Use either an oddesey lever or an avid lever. I prefer avid because it has a knob on the body of the lever that allows you to adjust the lever throw while you're out riding

 

[TheBuzzard]

3099 is missing the threaded adjustable cable holder to stop the cable from just coming thru the hole. I've made a lot of trim setups. You can use the ends off old throttle cables . If you smashed that hole with a hammer so the cable housing can't fit thru it, it would work too.

 

[red_ak_ranger]

Use either an oddesey lever or an avid lever. I prefer avid because it has a knob on the body of the lever that allows you to adjust the lever throw while you're out riding

Thank you. I see Avid levers are very affordable too.

3099 is missing the threaded adjustable cable holder to stop the cable from just coming thru the hole. I've made a lot of trim setups. You can use the ends off old throttle cables . If you smashed that hole with a hammer so the cable housing can't fit thru it, it would work too.

Old cable has it still attached (see photo of old cable) BUT I do not think that I can remove it and install it on photo 3099 above. My assumption is everything has been "crimped on". Hence the advise by Roseand "buy the red part straight from xscream"