SHOW OFF YOUR BLASTER

Vumad

Super Hero, with a cape!
Location
St. Pete, FL
I have two layer of turf on the actual seat top and and just one layer on the sides. I used that expanding foam in a can. I think "tthe great stuff" or something like that for filling in cracks and insulation @Quinc

Next time you should consider hydroturf under pad and shaping it with a DA. Great Stuff is basically a sponge. It looks great though.
 

Fro Diesel

creative control
Location
Kzoo
Worked great until crummy sbt headgasket went after 45min ride. Going to check head/deck surfaces.
It was just a rebuilt 6m6 ported 701 190psi
9a5f8f83f256124102a1fc7341dda531.jpg

4702e4963e7f9e4c91b63a701c149ab8.jpg
 

Fro Diesel

creative control
Location
Kzoo
headgasket!? What is this the 80's. Get an oring head. :)
It was 80 out, but the water was more like 50. I know i should prolly just drop my HPE in there, but this 6m6 ported motor has been my favorite cheap engine. I should have retorqued the headbolts after heat cycling. I may try an oring head while my new motor is in transit.
 
Top Bottom