sj Stock motor tricks jetting water routing ect.

[BruceSki]

i did....stuff a rag under the butterfly...leave a magnet sitting on the butterfly itself..it will catch the little screws....pull the screws...

this is my fourth carb done like that without any issues.

 

[Watty]

I've found the stock squarenoses retain a lot of water in the waterbox, as all the pipe cooling water makes it's way out there. Put in a T like SFL said, and run a pisser overboard like the later 701's.

 

[CarFanatic]

chuck.. You said to take out the screens.. does this cause any issues? IT gives a performance gain?

 

[Big Kahuna]

remove 2 of 3 screens

 

[CarFanatic]

Mine only had 2 screens I think?? one on top of each carb.

 

[Big Kahuna]

then someone already removed 1 of them.

 

[CarFanatic]

where did the other screen go, when it was installed?

 

[pimpchevy07]

if you pull the rubber off around the screen you will notice there are 3 screens for each carb.

 

[CarFanatic]

ah.. so take out 2 and just leave one in?

 

[pimpchevy07]

yea

 

[CarFanatic]

ah gotcha! ok!

 

[Vumad]

Pontoons! I have a set. They are great. My girlfriend or I can ride the X2 like a regular sit down. I can take my X2 to the river that's idle speed only. They kill the handling of the ski, but they only take 4 bolts to put on, so they are quick and easy for the right purpose. I really like them because it makes my X2 more versitile. I only have the back 2 pieces though. I wish I had the complete set of 3.