portlandbucfan
portlandbucfan
- Location
- Portland, OR
Ski has run perfect over the years, used it last winter, had it sit two months this spring, notice my primer kit was off in a couple pieces and the pump was bad on it
Had a new primer kit installed today, and was told to prime it in the water? tried for 2 hours and nothing, tried out of water noting also
I see gas at the top of the primer kit (clear round peice) but no gas is going through the primer tubes.
I shoot Starter fluid down the carb hoping that would help get gas flowing but still nothing. It starts and runs for one sec then dies (obviously only running on the starter fluid) Carb is good, just somewhere is not getting gas or im not properly getting the primer kit broken in the right way?
any help is appreciated
Had a new primer kit installed today, and was told to prime it in the water? tried for 2 hours and nothing, tried out of water noting also
I see gas at the top of the primer kit (clear round peice) but no gas is going through the primer tubes.
I shoot Starter fluid down the carb hoping that would help get gas flowing but still nothing. It starts and runs for one sec then dies (obviously only running on the starter fluid) Carb is good, just somewhere is not getting gas or im not properly getting the primer kit broken in the right way?
any help is appreciated