Blaster ski running bad... breaks up under load... plugs milky ?
- Thread starter BlasterDisaster
- Start date
BlasterDisaster
Back Flips & Barrel Rolls
- Location
- Wilmington, NC
That's the plan! About to put my factory pipe on it and put it back together. Might as well upgrade while in at it!
BlasterDisaster
Back Flips & Barrel Rolls
- Location
- Wilmington, NC
Well, the hondabond held great for about 3 minutes! My head is probably a little warped. Who knows. The one thing I do know is it ran perfect until the hondabond have out which means my problem had to be the head or exhaust gasket. Sweet! Ordering a new headgasket tomorrow. Thanks guys!
BlasterDisaster
Back Flips & Barrel Rolls
- Location
- Wilmington, NC
Well I know I've overheated this thing a couple times and I beat the absolute 
out of it and of the 3 previous owners over the last 7 years, I know it's been ridden hard and probably overheated a multiple times so I kinda figured that if the head was warped at all that it wouldn't hold.... But it did hold long enough to verify that the headgasket was in fact the issue.
No worries... Ill shave the head and put an oem gasket on it this week.
On a side note... I installed a factory pipe with a mod chamber last night and damn it woke this ski up! For a few mins.... Haha
out of it and of the 3 previous owners over the last 7 years, I know it's been ridden hard and probably overheated a multiple times so I kinda figured that if the head was warped at all that it wouldn't hold.... But it did hold long enough to verify that the headgasket was in fact the issue. No worries... Ill shave the head and put an oem gasket on it this week.
On a side note... I installed a factory pipe with a mod chamber last night and damn it woke this ski up! For a few mins.... Haha
Superjetjim
X-
Your exhaust gasket has gone mate, seen it twice recently, it sucks water in from the head/mani gasket on the down stroke hence lack of perf and milky stuff.. Chance your exhaust gasket and your set.
Jim
Jim
BlasterDisaster
Back Flips & Barrel Rolls
- Location
- Wilmington, NC
where were you a few weeks ago?! hahaha IT WAS the exhaust manifold gasket like you stated.... I replaced it and installed the factory pipe i had colelcting dust and I'm back in business!
Thank you for taking the time to respond here. Hopefully this thread will help the next guy who's having similar problems.
-Erik
PS- I replaced my head gasket at the same time but even though it looked rough, it didn't show any signs of leaking.
Thank you for taking the time to respond here. Hopefully this thread will help the next guy who's having similar problems.
-Erik
PS- I replaced my head gasket at the same time but even though it looked rough, it didn't show any signs of leaking.
- Location
- md's chesapeake bay
damn.............