Used Sold 162 xscream pump/thrust trim

[Eli760]

Sold
162 xscream oring style pump 1000$
Two impellers 275$ each or 500$ for both. One is a 6/15 I’ll get specs for other with pictures
Thrust 155 trim with bored reduction and steering nozzles 500$ without trim lever 525$ with. Or 2000$ Shipped for everything
No drive shaft/bearings/seals

 

[McDog]

What engine setups would you run those props with?

 

[Eli760]

What engine setups would you run those props with?

I ran a 1200eme think the previous owner ran a 1200 dasa.

 

[Jyzmbe]

What are the exact prop diameters


Sent from my iPhone using Tapatalk

 

[Eli760]

What are the exact prop diameters


Sent from my iPhone using Tapatalk

Good question I’ll measure tomorrow once I figure how. Might have to get a circumference and do math or put in pump and use feeler gauges And subtract from pump diameter. 161. something is my guess tonight

 

[Eli760]

Is feeeler a bad word when spelling with 2 e’s

 

[Jyzmbe]

A micrometer would be the best way


Sent from my iPhone using Tapatalk

 

[Eli760]

Mine only goes up to

A micrometer would be the best way


Sent from my iPhone using Tapatalk

mine only goes up to 6inches 152mm

 

[Storbeck]

A micrometer would be the best way


Sent from my iPhone using Tapatalk

Can you show me how you measure an impeller with a micrometer

 

[Jyzmbe]

Can you show me how you measure an impeller with a micrometer

I would use a bore guage to measure the id of the pump and measure that with a micrometer then subtract prop clearance


Sent from my iPhone using Tapatalk

 

[Storbeck]

I would use a bore guage to measure the id of the pump and measure that with a micrometer then subtract prop clearance


Sent from my iPhone using Tapatalk

Sure

I'm unclear on the part about measuring an impeller with micrometer.

 

[kevbo]

I mark the edge of the impeller every inch, set it on a table and measure the distance and rise. Then apply trigonometry.