Sold

[nick matthews13]

Hey guys/ gals. Selling my Rickter xfr built / finished back in April. The ski rips but it sits in my garage more than I ride it so I’d rather invest money elsewhere. Ski was only fresh water ridden and has 5-10 hours run time on it max Looking for 19k. Shipping at buyers expense Parts list below.

Parts new at time of build:
Hull w/ title (no damage besides life scuffing that will buff out from trailer bunks)
Et967 pump gas set up
PFP w/ JM waterbox
Midshaft assy
148 solas pump with 8/14 prop 5mm cut back
Aura lightweight pole
Thrust steering w/ rrp bars
Thrust trim/ finger throttle
Medium ride plate
Rhaas motor mounts
High torque gold series starter
Vf3 reeds
Wsm steering cable
Hot product filters

used at times of build:
-Thrust trim
-Sbn 46s with Jm brace and Jm throttle wheel(rebuild carbs)
-protec intake manifold with epoxied crossover
-rad dudes 3.25 gallon tank (waiting on rubber straps so ratchet straps are in place for now)
-62t electronics w/ lightened flywheel

 

[kyle lance]

Where are you located

 

[nick matthews13]

Where are you located

RI .. sorry about that

 

[nick matthews13]

Have had a few interests in part out. If hull sells first I will part out. 8k for hull as I prefer not to go this route (inc 3 thrust pissers, med ride plate, hull, rickter hood prongs, Yamaha latch, pole bracket, breathers, title, 148 pump shoe)

 

[Brian_polocoser]

Where are you located?

 

[nick matthews13]

Rhode Island as stated above. Will ship

 

[Rider712]

If you’d take 17k shipped (west coast). I’d be very interested in your ski.

 

[nick matthews13]

If you’d take 17k shipped (west coast). I’d be very interested in your ski.

thank you for the offer but can’t do 17k shipped

 

[drewfarrington]

Interested in a trade?