Spark and fuel, won't run?

Hey all, just put my ski together, jm760 61x. Primed the carb on first start up and it fired right up and ran clean. A week later I install a tank, prime carb and it won't fire. Fires for a second as you let off the start button every few times. I unplug the stop switch, doesn't change. I ohm the pulse coil and reads 15.2. So I replaced the msd enhancer. Install the new msd and still won't fire. Pull the plugs, they're sparking, spray ether in the plug holes and it won't start. As it is turning over for a bit with no start, it kind of "kicks back" and then keeps turning over. Any thoughts? Im very frustrated. Thanks
 

SKI BONEZ

SKI -BONEZ
I know u said u swapped enhancer but sounds like enhancer
Do u have a stock cdi to slap in and test?

Sent from my SM-G965U using Tapatalk
 
This is a brand new enhancer from jm. I can't imagine my original one and this new one are bad. I pulled the flywheel cover and the flywheel was not loose as far as grabbing it and trying to move it, but I wil recheck that.
 

Magnum Mike

Site Supporter
>Fires for a second as you let off the start button every few times.

check pulser coil wire (white with red stripe.) when it is disconnected skis don't start but rumble as you let go of the green button.
 
Top Bottom