Freestyle speedwerx dry pipe

[SuperJETT]

Speedwerx pipes have fairly tight water jackets, so definitely run a filter on the water feeding it. I clogged mine several times before putting a filter on it.

Excellent pipes all around.

There were a few runs of freestyle chambers run also that have a 2" longer headpipe section. They are hard to tell if they are that version or not though, you pretty much have to have it side-side with a regular race version to see the difference. They are slightly harder to get in/out of the hull because of it. Brad Lustic and I got the first 2 of them.

 

[SuperJETT]

Ok sweet, Ive found the inline filters in the Hot-products catalog.
This fitting should have the restrictor jet? mine is not straight like this one it just has a standard elbow
View attachment 212460

Yes, that one. If you run a flow control valve on it, you'll have zero water in the exhaust below it's opening point and can burn up your hoses.

 

[mattnz]

Ok cheers everyone. this explains a lot when i first was running it got blocked a couple of times as no water was coming out pissers. The pipe was second hand off someone and they didnt say anything about installing etc. so didnt really know what i was doing. But it came with no restrictor jet just a standard elbow same size the whole way through. where could i find these jets and the correct sizing?
watcon spray nozzles???

 

[just joe]

I use a jet screwed into the stinger fitting, i think i have a 190 main jet in there. You can also use this type of restrictor.

http://www.watcon.com/Catalog_Pages/Quick_Disconnect_Water_Restrictor.htm

I also run a flow control into the stinger on my dry pipes. It is true you could melt a stock rubber hose if you spend a lot of time at idle. I haven't haven't had an issue, but I also use silicon hoses.

 

[Big Kahuna]

Good to use a sand filter for any dry pipe or any pipe running electronic waterinjection.

 

[txsuperjetfreak96]

Can u run water injection on these pipes to get better bottom end hit if it is the race version

 

[Big Kahuna]

Yes. I had the race version but it had plenty of bottom end hit.

 

[txsuperjetfreak96]

Nice I was considering buying it from the guy and running it instead of a b1 mod chamber but not sure

 

[mattnz]

I use a jet screwed into the stinger fitting, i think i have a 190 main jet in there. You can also use this type of restrictor.

http://www.watcon.com/Catalog_Pages/Quick_Disconnect_Water_Restrictor.htm

I also run a flow control into the stinger on my dry pipes. It is true you could melt a stock rubber hose if you spend a lot of time at idle. I haven't haven't had an issue, but I also use silicon hoses.

Anyone know where to find/buy a stinger fitting which take the jets?

 

[Big Kahuna]

The stinger fitting was tapped for the jets to screw into.
It comes from the factory this way.

 

[just joe]

The stinger fitting was tapped for the jets to screw into.
It comes from the factory this way.

Yep, mine is tapped. Check to be sure you don't have one in there already.

Worst case go to Home Depot and pick up a 3/8 white nylon plug, drill it out and screw the jet in. Set it inside the cooling line at stinger.

 

[Christo]

Just picked up one of these pipes . Let the games begin