speedwerx racing pipe
- Thread starter dave440x
- Start date
Legdrag's
X-
- Location
- West Palm Beach
That pipe isn't easy to install for beginners. Plus you really need a good engine behind it for the power to be efficient. Not the best low end pipe either. Run a water injection too. I highly recommend running 110 race fuel too.
You are going to need some hoses to wrap the exhaust around the fuel tank towards the back.
You are going to need some hoses to wrap the exhaust around the fuel tank towards the back.
Legdrag's
X-
- Location
- West Palm Beach
Call Speedwerx guys and see if they still have directions too.
DaUpJetSkier
I like square
- Location
- Marquette, MI
thats very similar to a Riva dry for a 701.
I've heard the same thing. This pipe does not need water injection. I love this pipe but I am a B pipe convert now so I don't know what I'm gonnna do with it. It rips hard though just not as hard as a B on the bottom.
Mandatory sea strainer on this pipe and a double coupler really works well.
Mandatory sea strainer on this pipe and a double coupler really works well.
yeah it kind of help...
what i need is the final product since it exhaust in front.
i imagine the stock waterbox is not used.
what do i do with the end ...
Sorry but I dont even know what is a SXI.... :smile: :smile:
I am just kidding but I really never wrench a Kaw.
I am an YAMAHA only guy....I just perceived that people post pics of YAM setups.
I personally have 3 Speedwerx for YAM... it rips.
Gera
Big Kahuna
Administrator
- Location
- Tuscaloosa, AL
You either have to have a 180 degree "U" shaped diverter or remove the foam up front, us a flexible Hose, wrap around the nose, come back down the carb side, find an inline silencer then out the rear exhaust outlet.
Legdrag's
X-
- Location
- West Palm Beach
what kind of flex hose...
where can i get a straight silencer...
and can you explain me the back pressure.
i don t know much about jetskis, i never played in these before. i know alot on dirtbikes and snowmobile though...
do i need anything else with that pipe...
is my stock head enough, carbs, and do i need a dual cooling system
thanks.
- Location
- In the shop
The speedwerx is a little more involved than most. If you don't have the supplied v shaped aluminum tube to go around the gas tank/nose, you can use a 2" flexible radiator hose. You will need to remove your motor mount bolts and slide the motor frontwards. Do this for two reasons... to remove your stock waterbox, and also to be able to fit the chamber into place. Upgrade your cooling to 1/2" by replacing your pump and ex amnifold fittings. You can use your stock carbs, but you will have to play around with the jettin a bit. This pipe was ment to be used with serious engine mods. Hope this helps!
- Location
- Standston VA
That is what water injection fixes
Big Kahuna
Administrator
- Location
- Tuscaloosa, AL
Way to revive a dead thread!!!!!! LOL