- Location
- dallas TX
Im trying to replace my stock carb on my 750sx (93) with a super bn high performance 38mm carb will this mount right to my stock intake???
Super bn 38mm carb
- Thread starter throwedoff
- Start date
- Location
- dallas TX
answered the question it wont mount up.
issue im having is i had a guy rebuild the top end and put seals in the lower end off the motor ( reason being it ran away on me and scarred the rear cylinder)
when i get the motor back he tells me the throttle plate is loose on the carb and is causing my lean condition.
i put the carb on the ski anyways and try to start it, will not run unless my hand is held over the carb and then only idles for 8 secs or so and dies, now if i brap it a little and keep doing that ski will stay running.
I dont want to waste the cash on a new carb if it isnt my issue, im going to check reeds and go through the carb again tonight.
does anyone have any ideas?
issue im having is i had a guy rebuild the top end and put seals in the lower end off the motor ( reason being it ran away on me and scarred the rear cylinder)
when i get the motor back he tells me the throttle plate is loose on the carb and is causing my lean condition.
i put the carb on the ski anyways and try to start it, will not run unless my hand is held over the carb and then only idles for 8 secs or so and dies, now if i brap it a little and keep doing that ski will stay running.
I dont want to waste the cash on a new carb if it isnt my issue, im going to check reeds and go through the carb again tonight.
does anyone have any ideas?
- Location
- dallas TX
Fuel filter is brand new.
Carb was already gone through and put new parts in it.
ill run a compression test tonight and see what im getting.
Carb was already gone through and put new parts in it.
ill run a compression test tonight and see what im getting.
- Location
- dallas TX
that i cant do dont have a tester...the guy who did the motor said he did one, but i dont know anymore.
Hes saying because you can move the throttle plate up and down a little while its closed and quite a bit when its wot that its sucking in air at the throttle plate, and i need to replace the carb.
Hes saying because you can move the throttle plate up and down a little while its closed and quite a bit when its wot that its sucking in air at the throttle plate, and i need to replace the carb.
Magyar68
Really!!!
- Location
- Lewisville
this will put a Mikuni carb on a stock single intake meant for a Keihin.
https://www.rhaasproducts.com/ProductDetails.asp?ProductCode=38adapt
https://www.rhaasproducts.com/ProductDetails.asp?ProductCode=38adapt