- Location
- Lemont, Il
My superjet takes on a lot of water when i submarine. is there any hood mod i can do to reduce water intake?
Super Jet Superjet Hood Mod
- Thread starter jnitchoff
- Start date
- Location
- NYC/Long Island
You can seal up the holes on the front of the hood. Besides that, not much you can do.
- Location
- Lemont, Il
How do you seal them up? would that restrict air flow and the motor wont run as good?
- Location
- NYC/Long Island
Mine breathed fine when I experimented with it. Put some duct tape over it to see if it improves before you seal it up with fiberglass or something permanent. Also ensure that your hood seal is in good condition.
- Location
- Long Island , NY
Hood seal is most important
Vumad
Super Hero, with a cape!
- Location
- St. Pete, FL
You seal up the front holes by fiberglassing them closed. The rear holes may not be sufficient by themselves. If they are not, you can open them up.
