- Location
- merrick ny
I have a superjet and I just got a new prop for it. I am planing on doing it myself is there any tips for doing it Or special tools?
Superjet prop
- Thread starter tjs618
- Start date
Mark44
Katie's Boss
- Location
- 100% one place
Yes make sure you have the tool that matches the impeller you purchased and a spine holder for your shaft that you can put in a vice.
mgander17
Site Supporter
- Location
- Lemoore, CA
The prop is reverse threaded
- Location
- Seattle, WA
What these guys said. Left hand thread, so when looking down the shaft at the impeller, spin the impeller clockwise to remove it.
Also, good read here: http://www.x-h2o.com/index.php?threads/superjet-impeller-removal-and-replacement.2466/
I replaced my stock '93 impeller last week. That SOB is tight after 20 years. I used a heat gun, a vise, a 4 foot cheater bar and nothing...would not budge. Finally heated the threads on the back end with a propane torch for almost a full minute and it broke loose with help of cheater bar. Heat is your friend.
Also, good read here: http://www.x-h2o.com/index.php?threads/superjet-impeller-removal-and-replacement.2466/
I replaced my stock '93 impeller last week. That SOB is tight after 20 years. I used a heat gun, a vise, a 4 foot cheater bar and nothing...would not budge. Finally heated the threads on the back end with a propane torch for almost a full minute and it broke loose with help of cheater bar. Heat is your friend.
- Location
- Lancaster, PA
Driveshaft holder, 27mm wrench and a torch.