Sxr motor in superjet rn
- Thread starter Parkersxr
- Start date
Yami-Rider
TigerCraft FV-PRO
- Location
- Texoma
Anything is possible. IMO is it worth it? no.
Mark44
Katie's Boss
- Location
- 100% one place
LOL why sure you can
Big Kahuna
Administrator
- Location
- Tuscaloosa, AL
There have been a few SXR SuperStock motors that I would love to have had in my SJ!!!!!!!!!!
That said, do not know of any conversion kits, usually its the other way around, people wanting to put SJ motors in X'2 or 550's
That said, do not know of any conversion kits, usually its the other way around, people wanting to put SJ motors in X'2 or 550's
Big Kahuna
Administrator
- Location
- Tuscaloosa, AL
If you have the driveline, I would suggest finding an AM hull that is direct bolt in....... Personally, I never had a lick of trouble out of my SXR vs SJ. SJ, all kinds of electrical gremlins, Granted, My SJ was riden harder, but my SXR was a race ski.....
- Location
- Cruising Around
Rad Dudes plate and it goes right in. Leggdragger put his Kawi/DASA in his SJ recently I beleive. Good luck and have fun
Big Kahuna
Administrator
- Location
- Tuscaloosa, AL
Gonna have to be a yamaha.
makejetskiinggreatagain
Brandon
Blasphemy!
- Location
- Cruising Around
What about it?
Half flip95
Formerly pondracer95
- Location
- Lake Havasu City AZ
I know this thread is older, but i'd take that sxr hull off your hands... i have a few SJs laying around that we could make a deal on.
p.s. where you been all summer??
p.s. where you been all summer??
I recently rode a freshly built and ported sxr motor that i would rock all day..much much more power than my 650 yamaha..the power band on the sxr engines seem to be higher to me, but going fast is coming back.
I'm not saying the op's question is ideal...converting a yami boat for a kawi driveline...but can anyone comment on what the process is/was like?
I'm not saying the op's question is ideal...converting a yami boat for a kawi driveline...but can anyone comment on what the process is/was like?
Last edited:
- Location
- Cruising Around
Step 1-Buy Rad Dudes bed plate. Step 2- Get Rhass short "couch" mounts. Step 3- Measure coupler gap and get custom length Cold Fusion (or another brand) drive couplers. You may also just be able to shim or trim couplers depending on actual midshaft in use and hull setup. Done have fun.
849tigerbotkv1
formerly ihate5mphzone
- Location
- where i can ride 2stroke
thats too much like work just buy my ski
http://www.x-h2o.com/index.php?thre...kawi-bb849-motor-kawi-driveline-setup.152974/
- Location
- Cruising Around
Just put my DASA stroker package in front of a 148 MAXXX in a RokR for that. Worked out well, guy is real happy. Pretty much the run down of how it went. A big plus with the Rad Dudes plate is choices, you can go back and forth between the Yami and Kawi pretty easily. I like choices
Last edited: