Tanman's Square Nose

[SkiDiggity]

sounds good to me

 

[Tanman]

Pump seal in the mail.

Your the man : )

 

[Tanman]

Well I got my decals all made up by Sign Pro of Ketchikan, they look cool, all are designed by me to respresent my TNT Kustoms, except blowsion and monster of course. I have a cool TNT decal on the bottom too you will just have to wait and see I also have MONSTER going verticle down the handlepole to do same as my old 550 for those who remember that ski.

I am running a protec pipe of my dads for now, good weather is comin and I want to just get running!! haha.

I am waiting for my throttle adapter, wear ring, and getting my turf done and this thing is good to go

Got my dual bilges in


oh and I have to make a small bracket for the protec exhuast the front lord mount is just free floating. and I need to find a 10mm x 1.25. by like 5 inch bolt for this Protec pipe also. so there is a snag anyone got one?

let me know what you think

 

[fals3illusion]

looks good man! looks liek an xeon green ski!!

 

[Tanman]

K so it was my very first turf job ever. Completely by myself...I think it went well. I came up a little short under my FFH and a little in the back of each foothold. but other than that it looks good. I gotta get some stainless hardware for my kick plate I made


My pump is shimed and in. What I B#@!CH that was my impeller woudn't spin freely once the pump was tight so that took a while to get right and then my engine went it.

Pro-Tec pipe had to have a lord mount built by Motorheads5 to make that pipe work. but it is lookin good. My limit stap is all secure. I am knockin on the door of a shake down cruise in a few days well see how it goes....

 

[Tanman]

well after a few minutes of wondering why it wouldn't start I put a lanyard on my handle bars and wahooo it runs. fired up and idles no problem but it rev limits out very low in the RPM range. I have been thinking cause I ran it a while with no coolant was circulating that the temp sensor hot just hot enough to put it in limp mode.....anyone have any ideas? I have to get my primer, and pole spring from blowsion. then later I will have to turf my rails when I get some turf and this thing is good to go... I hope


but the limp mode problem.....???

 

[Tanman]

well i took it up and rode it and there was no rev limiter problem, so for now the pink wire is staying hooked up. But my engine alignment is a little off I have a vibration so I gotta fix that and my botttom end seems really rich I think I even fouled brand new plugs I is set up for the stock waveraider intake and exhaust I believe so does anyone have good experience with tuning this sort of set up?


Thanks Tanner

 

[Crab]

well i took it up and rode it and there was no rev limiter problem, so for now the pink wire is staying hooked up. But my engine alignment is a little off I have a vibration so I gotta fix that and my botttom end seems really rich I think I even fouled brand new plugs I is set up for the stock waveraider intake and exhaust I believe so does anyone have good experience with tuning this sort of set up?


Thanks Tanner

did you bend the driveshaft? put a dial indicator on it

 

[Tanman]

Would I bend it riding it for 10 mins? or in my install? ill check it out.

 

[Motorheads5]

He's talking about bending it when you removed the old impeller and installed the new one by having the driveshaft in the vise and sideloading the shaft.