Freestyle Tech tip...

[aqualocos]

Hey

 

[Factory928]

Mikuni SBN Carburetor Check Valve install.:

 

[aqualocos]

Haha greatt thanks!!!

 

[Vumad]

I use a punch with a blunted tip and no chemicals. gently push it in from the back, then lift up the edges from the front.

 

[restosud]

I use a punch with a blunted tip and no chemicals. gently push it in from the back, then lift up the edges from the front.

sure you're talking about carb check valve there cowboy?

 

[Vumad]

sure you're talking about carb check valve there cowboy?

Yes

 

[Roseand]

I tried the floss method and it was still a bitch. This time I bought the tool and we'll see how effortless it is lol.

 

[aqualocos]

The flos is not easy at all!! i used an allan wrench 1.5 mm with a round head on it works great

 

[Krenn Power Sports]

i just lay disc on, put rubber at angle so 1 edge is leading thru the hole, use a "micro" flat-head screw driver to push the other edge down into hole and done.. no mar, and done in about 15 seconds.... It does take some practice if you haven't done it before... i have a blunt tool but still sometimes it goes thru it..

 

[smoofers]

I use a punch with a blunted tip and no chemicals. gently push it in from the back, then lift up the edges from the front.

I do the same thing, although I usually lick the rubber for just a bit of lubrication (make your jokes). In the hundreds (maybe 50's) I've installed, I've found that pulling the edges through from the other side is the key.

 

[Roseand]

I bought the tool. I lube it with a little wd40,insert the tool, and it works absolutely perfectly. Never punctures through. Totally worth the 10$.

 

[Quinc]

I use a little two stroke oil on the rubber part and push it through with an Allen head. @Roseand where did you get the tool?

 

[Roseand]

EBay

 

[NorCalSJ]

Awesome video Thanks