throttle response?

[lani]

Is their any way to get better throttle response on a stock 701 sj without buying parts?

 

[OCD Solutions]

subscribed.

 

[MADMAT]

A free prop? A free billet aluminum charging flywheel? A free total loss system!

 

[MADMAT]

Mill your head to get 195psi...for free?

 

[Quinc]

Mill your head to get 195psi...for free?

If you have a file and A LOT of time it could be free. =)

You could lose 20lbs.

 

[Roseand]

Just get a piece of glass, lay a sheet of sandpaper down and go to town.. Hahaa

Sent from my XT907 using Tapatalk

 

[lani]

Lol dam I was hoping for some tuning trick or something lol

 

[amitchell]

You could port for cheap, still need to buy gaskets and not scratch the bore up.

 

[lani]

Where do u get a motor ported.. cause I noticed on the factory b pipe mod it says for ported motors.. would it hurt the motor
If it wasn't ported

 

[MADMAT]

B pipes kick ass on non ported motors!

Go B pipe, prop, and raise the compression to 195psi IMHO.

 

[heynagel]

Can't you advance the timing a bit? That's free.

 

[OCD Solutions]

^^^^ Good call! 3 deg advance is a nice little improvement.

 

[MADMAT]

Yep forgot about that!

 

[lani]

How do I go about advancing the timing 3 degrees

 

[OCD Solutions]

You will have to remove the front cover from the engine (flywheel cover), remove the flywheel and then loosen the bolts and turn the stator by 3 degrees. Easy to say, not necessarily easy to do, especially if you don't have the right tools but it is free as long as you don't mess anything up like the gasket for the flywheel cover.

Special tools will include a flywheel puller and something to keep the engine from turning.

 

[MADMAT]

Don't let the flywheel puller bolts go to far in and smash a coil on your stator!

 

[simofx-1]

me being me i would get some 1 to advance the timing 4 me because i dont no what im doing, but you can use a impact hammerdrill to remove flywheel bolt with out anything holding engine(just dont tigthen it with the impact as you will snap the bolt, like i did and its not 2 funn)

 

[lani]

I got plenty of tools and can rent the puller.. but are there timing marks to measure advance and retard with direction is which

 

[Quinc]

What if you advance 4-5 degrees, is it safe with higher octane fuel and noticeable over 3 degrees?

 

[Harbor]

What if you advance 4-5 degrees, is it safe with higher octane fuel and noticeable over 3 degrees?

It's too much timing, it will be 25 deg at rev limit. Would be ok for low end but you'd have to ride responsibly and so would anyone riding your ski and it seems they all ways want to hold it wide open