- Location
- bayarea, ca
What steering nozzle is everyone using for the thrust ez pull trim set up. The steering nozzle I have binds up bad, and won't really turn either direction. The steering nozzle came from a stock trim set up
Super Jet thrust trim
- Thread starter frankv510
- Start date
- Location
- Valley Springs, CA
Should work perfectly fine, give it a light sanding on the spots catching
Sent from my SCH-I545 using Tapatalk
Sent from my SCH-I545 using Tapatalk
- Location
- Cleveland, Ohio
Make sure you didnt over tighten all your bolts. That will make it seem like its binding up.
- Location
- bayarea, ca
Yea, I figured I would have to sand it. Thanks
- Location
- Long Island
I grinded my 08 nozzle on the top groove only where it was catching the trim cable bracket.
You can't over tighten the bolts because there are top hat spacers. You can over tighten and strip the bolts if you tried hard enough though.
You can't over tighten the bolts because there are top hat spacers. You can over tighten and strip the bolts if you tried hard enough though.