Tool to reach your carb adjustment screws

Quinc

Quinc

Buy a Superjet
Location
California
Should make it a little easier to tune the carbs at the beach:
https://www.amazon.com/ALPHA-MOTO-M...ds=carburetor+90+degree&qid=1599083315&sr=8-5

312Gu4sm3hL._AC_.jpg
 
Roseand

Roseand

The Weaponizer
Site Supporter
Location
Wisconsin
If you don't already have t handles, extreme throttle knobs, or the 3d printed knobs.. A long reach needle nose pliers for the lows works great. Not needed for the highs but still works.
A dime/washer/other coin works decent too.
 
MADMAT

MADMAT

Location
Ohio
Just curious now! What are all of the choices? I had the knobs fall off years ago and out the scup they went. I have T handles on low end but still not ideal. What are these 3 D printed ones?
 
Big Kahuna

Big Kahuna

Administrator
Location
Tuscaloosa, AL
MADMAT said:
Just curious now! What are all of the choices? I had the knobs fall off years ago and out the scup they went. I have T handles on low end but still not ideal. What are these 3 D printed ones?
Click to expand...
They are plastic. I has the Jetski Solutions once on a single 44. I kept having to constantly tune the carb. one day I set it. made a mark, went and rode for about 10 minute came back it was almost a quarter turn out. re set, went back up the lake and on the way back it had gotten to where it was running like crap. got to shore, popped hood and it had 1 or 2 threads holding the entire adjustment screw in, the weight of it was causing it to vibrate and unscrew itself. Never again. T Handles or nothing and just use a screw driver.
 
V

vcolf

If it is for your personal ski, why not just go to Ace HW and pickup some SS roll pins, cross drill your adjust screws, and make T handles? I think I have some spare roll pins I can send you. I bought bulk and later realized they sold better ones at Ace.
3207cfe4b5c7bfb38093c51d10b4a292.jpg



Sent from my iPhone using Tapatalk
 
You must log in or register to reply here.
Top Bottom