FX-1 Turfing question on FX1

[SXIPro]

Ok, so the side panels are held on with 14 rivets total and the dash with 2 rivets. The HT kit came with 6 very long rivets...

Once old rivets are drilled out, I'd imagine I should seal the holes.?..100% silicone or marine jb weld ok, or do I have to break out resin and stuff?

Where does HT expect me to use the 6 long rivets? the rear 'bond rail cover' is held on with 6 studs and nuts, and that is the only multiple of 6 I can find.

 

[BostonSJ]

I always turf the rails all the way around. Did that on my FX1 as well. If you want to use the cover then yes use them on the back. If you don't just turf over holes. The holes in the sides I would use marine epoxy.

 

[Big Kahuna]

most likely for the plastic corner pieces or the plastic strip that goes across the back between the corner pcs and the dash pad?