- Location
- Michigan
Looking for the mounting plates to put a 701 based motor into my krash TIA
Want to buy krash conversion parts
- Thread starter Evan_Alonso
- Start date
- Location
- Lake Lanier
I have a 701 in my foot rocket if you need any photos I can send you some.
- Location
- Michigan
Do you happen to have measurements on the bed plates to do the conversion. I know I can get them from krash but I think I can make them for cheaper and get them sooner than 3-4 weeks
Maybe @brapperdoodle can chime in
- Location
- Asheville, NC
I just cleaned mine up, I will take some pictures and measurements later today and post them here! Good timing haha
- Location
- Michigan
Sweet thank you
- Location
- Asheville, NC
Hope this helps, these are out of a 2014 Krash Predator. I haven’t been able to install my engine yet to check alignment, but they have been in there since 2014 so they must be close enough! The one with the wear mark is the port side rear engine mount. (left side, rear)
- Location
- Lake Lanier
Here are some pictures of a 701installed It’s a 2020 Krash but the plates look the same.
Attachments
- Location
- Michigan
All this stuff helps out thank you now to make some bed plates to get into the ski
- Location
- native idahoan
You don't need conversion plates. I put a Yamaha 789 in my 2020 reaper. All I did was swap plates left to right then drill and tap new holes.