Which TL do I buy?
- Thread starter Eric C
- Start date
bad93blaster
X-H2
SUPERTUNE
Race Gas Rules
- Location
- Clearwater Fl.
Single channel MSD -TL without a thought. But you need to think about how much salt water riding you do. MSD's run good because they have a lot of spark power, but when used in salt water can be fussy and short out when they get wet with salt water. Proper installation and dielectric grease are a MUST!
If you look at my sig's below...4 out of 6 have MSD-TL's I set-up!
If you look at my sig's below...4 out of 6 have MSD-TL's I set-up!
Last edited:
hangtime
Speak up ,don't kiss azz
- Location
- WORCESTER,MASS- HAMPTON N.H.
He only rides salt .You better get triple A for all the tows back to the ramp your gonna need with TL
SUPERTUNE
Race Gas Rules
- Location
- Clearwater Fl.
If that's the case get an Advent CDI (you can get them from me) and use stock yamaha 62T stator and flywheel, or if you just want so, so, power... go msd inhancer
- Location
- South Africa
Dont mean 2 hijack the thread, but I went thru 2 msd tl in the last week(I must add it was the older pro2) but im in the same boat as Eric C......
Is the new msd a lot better than the new blowsion advent,wax,or others and can one buy just a brain box and wires?
Thanx.
Exile.
Is the new msd a lot better than the new blowsion advent,wax,or others and can one buy just a brain box and wires?
Thanx.
Exile.
- Location
- South Africa
Well ive 2 got pro2,it worx fine outside the hull but once installed it doesnt always pickup correctly(irritating though) but what expensive and where could I get just the brain box if nessecary.....
Thanx Matt E
Thanx Matt E
- Location
- South Africa
Thats the problem spoton! But how do I rectify that? Wev bn installing and checkin everything so slowly so that we dont miss anything....... then error,error.... the subscriber you have dailed is not available and do it all over again....
You need to make sure that the clearance between trigger surface and flywheel surface is 0.045 - 0.095 inches.
Take the flywheel off, put some sticky clay, playdoh, whatever, on the surface of the pickup, reinstall the flywheel (including boiling it and torquing it! , then rotate a few times.
Take it back off, and carefully measure the thickness of the material on the pickup.
Take the flywheel off, put some sticky clay, playdoh, whatever, on the surface of the pickup, reinstall the flywheel (including boiling it and torquing it! , then rotate a few times.
Take it back off, and carefully measure the thickness of the material on the pickup.
- Location
- South Africa
Thanx Matt..... appreciate the info!
Back 2 topic, Eric C msd is the way to go I think.
Back 2 topic, Eric C msd is the way to go I think.
bad93blaster
X-H2
this is going on his flatwater boat he is building
- Location
- Down stream of Harrisburg, PA
Sorry for the but in, but with a total loss, on average how long does it last before your battery dies? I thought about getting one, but if my battery dies i will float over a dam:frown:
- Location
- Clearwater, FL
Hey Chuck why do you recommend the single channel and not the dual channel? I thought the dual channel was better and if the single channel brain takes a crap on you then aren't you poop out of luck?