Engine WTB. Cast Lamey/Dasa/R&D/Riva cylinder (small bore original)

[MTRHEAD]

WTB: Cast cylinder. - SMALL BORE not big bore Preferred

Can be:
bare cylinder, old before PV
stock, 5, 8, 10, stroke

please PM

 

[Big Kahuna]

I have a really old one that has been welded up, Non PV. It would need to be resleeved. It is ugly... This was Tricky's at one time, he welded it up, ran it, my buddy bought it and ran it for a few years.......

 

[MTRHEAD]

When you get a chance send a pic.
im sure I’m going to need to post for sleeves Someday. I know people have them because so many people went big bore

 

[tricky1]

I have a really old one that has been welded up, Non PV. It would need to be resleeved. It is ugly... This was Tricky's at one time, he welded it up, ran it, my buddy bought it and ran it for a few years.......

Its junk.

 

[Big Kahuna]

Its junk.

Then why you sell it to Chris!!!!!!!!!!! John, It is tired, Will send you pics. But it is pretty rough. But screamed in its day.

 

[tricky1]

Then why you sell it to Chris!!!!!!!!!!! John, It is tired, Will send you pics. But it is pretty rough. But screamed in its day.

It was running at the time. It has been decked and rewelded many times. Last time it was used I had a custom cut set of domes for it as the piston was 3mm above the top deck. Pretty sure it will make a good conversation piece.

 

[MTRHEAD]

Lol. I sold some brand new castings like dummy a few years back.

 

[senor]

What’s the going rate for one ?
Stock stroke
85 bore with kawi flat tops
Custom cut ada domes
Power valves
Manifold and head pipe spacers so no need to modify head pipe

 

[TheBuzzard]

There was some beat down welded ones in Japan from the bun guys on ebay some years ago. No sleeves. May still be on there.