x2 guys trim

D

doctorace1

Location
south fl
trying to install not working out to well,
does the rod need to be adjusted that comes from out the hull top,
cannot find a lever that works for his cable
has a allen key screw that does not allow for lever to actually do its job unless its removed,might possibly need to adjust the shaft to keep the function of the allen key screw but i have no clue and no info with it
very frustrated and help would be awesome thanks
 
ADDict

ADDict

I had a hell of a time getting mine installed, yes you will need to adjust it all. I believe I used his lever at first, can't remember.. I know I couldn't use his cable long as it rusted up pretty quick, I ended up modding a stock kawi throttle cable to work with his setup, and I also ended up using the UMI trim lever. I remember having to grind/clearance a little bit of the hull and metal trim ring where the trim rod comes through the top of the hull. Good luck, you'll get it.
 
D

doctorace1

Location
south fl
yea it was a little adventure not too bad was getting frustrated at first but i stepped back and looked at it better and was able to diagnose my issues,one being the guy at the bike shop kept trying to sell me all these fancy type levers,when i brought the cable is when the dude gave me the right one,thanks again
 
X2guy

X2guy

Location
Barrie, ON
Mabye. I'll whip up a set of instructions to go with them. # things you need to do. Clearance the metal boot retainer ring up top to clear the cable end fitting, Adjust the cable shorter, Cut the half circle piece off the edge of the pump nozzle to get more throw. I'm always here to help in case you need it.
I agree about the cable. I'm not 100% happy with it. Works fine in fresh water. I did change the inner cable to stainless but I want all to be stainless, Hard to find the parts I need at a good price.
 
You must log in or register to reply here.
Top Bottom