Xmetal Steering Rebuild Kit?

Ducky

Ducky

Back in the game!
Location
Charlotte, NC
I have an Xmetal steering setup that needs a full rebuild kit. Does anyone know if this would use the same type of kit as an rrp steering or umi steering? Anyone have a link to these parts? I tried searching, but didnt find anything specific to xmetal steering.

Thanks!
Matt
 
mindless

mindless

X
Location
VA
You only need 1. I ordered 4 as it was so cheap.
I think that's all you need. You may need o-rings at some point, but that bearing should be sufficient.
 
Sasquachcrap

Sasquachcrap

Location
North Carolina
I used thrust bearing on my home made pole that was on my old square nose. Smooth as silk but had to replace them after each beach trip. I'm making some bushings for my dad's beach cart this week. I ordered 4 feet of solid 2" round slick nylon rod. Can I make something for it out of that. Would only take a minute on the lathe. Bring the pole up with that shaft.
 
mike b

mike b

Michael "Mayhem" Bevacqua aka MikeyChan
Location
California
I need to do this same thing. Now there are two thrust washers on the XS setup. One under the steering plate and one on top. Are they both the same size? I didn't want to pull my steering apart because its all together but I do need to rebuild it all
 
Ducky

Ducky

Back in the game!
Location
Charlotte, NC
mike b said:
I need to do this same thing. Now there are two thrust washers on the XS setup. One under the steering plate and one on top. Are they both the same size? I didn't want to pull my steering apart because its all together but I do need to rebuild it all
Click to expand...

Rick at Xscream said:


Hi Matt,

Our adjustable steering system uses a total of 4 – thrust washers, and 2 – thrust bearings per system; the bearing is sandwiched between 2 washers on each side of the turn plate. -We sell bearing/washer replacement kits here for $20.

Regards,
Rick
 
You must log in or register to reply here.
Top Bottom