Search results

I'm running the 701 QS with Renthal fatbars CR high bend. Cut an inch off the ends to make narrower. Love them.

I use the blowsion versiplugs. My hull stays bone dry. Just run my bilge when I end up upside down

I've borrowed a friends stock b1 cover and no luck with it fitting over the aftermarket bars either.

I had the exact same symptoms on my blaster. Turned out to be water in my fuel. Had a cheap paper fuel filter on it. According to my local mechanic the filter would swell from the water just enough to choke it and not allow enough fuel through. A quick swap out with a new filter and she runs...

I bought the jet tribe cover. It looks and feels like good quality but I could never get it over my bars. I have the 701 quick steer with renthal fat bars. They are the cr high bend with 2.5" inches cut off them. Eventually planning on taking the cover to a seemstress make a little wider to fit...

Finally got around to taking a couple pics of the struts on my blaster.

I've got a set on mine and love them. Every time I open my buddies blaster up it makes me appreciate them that much more. I'll try to remember to get a couple pics to throw up here tomorrow.

From what I understand here in Okaloosa county, where Destin is, it is illegal to launch from the beach unless you have paid for access rights to the city. Most of the time we launch from the public parking at the base of the Destin Bridge. The closest boat ramp to the east pass is beside Dewey...

My remote died after using it two or three times in salt water. I liked using it when I had the camera mounted on my helmet. Probably going to order another one and cross my fingers that it lasts longer than the first.

Thanks guys. Doing the turf was a pain. First time I've done it. I liked the way it turned out though. Putting the bilge switch in the start/stop housing was more work than I expected. I had to mill out some of the plastic in the housing to seat the switch body in deep than just cutting the hole...

Thanks. I'm Destin FL. Here are a couple more pics on some progress I've made. Installed switch for bilge in start/stop housing and some turf. Not finished with the turf yet but getting there.

I needed a good excuse to get off the couch and out of the house so I decided I needed a new toy. I decided on a B1. Had talked to the local ski mechanic and had him build me one. Had it painted before I took delivery of it. Rode it all winter in the cold and it is now time to give it some love...