Search results

Thanks for the link, good read

Rear crankshaft seal blew out. My plan was to just pull bottom cases and replace all seals and be done but.... noticed two of the crankshaft alignment pins are either pushed in or worn down.. Is there anyway to remove and replace these pins? Or am I screwed? Sent from my SAMSUNG-SM-J120A...

Is there anyway to make a throttle cable from a single carb motor fit a dual carb motor?? It's for a 2000 rn superjet. Just about have it all together but the cable that came with ski seems to long. This ski did come with a 61x single carb setup. I since went to the 62t/61x combo. Any help...

If nothing, take plugs out check compression. Sent from my SAMSUNG-SM-J320A using Tapatalk

I would try taking plugs out, bump it over a few times. Install fresh plugs and try it then. Sent from my SAMSUNG-SM-J320A using Tapatalk

Yeah I'm going to try and drill out the other two Sent from my SAMSUNG-SM-J320A using Tapatalk

Will a ride plate and intake grate from a 2008 fit a older rn superjet?? Sent from my SAMSUNG-SM-J320A using Tapatalk

Thanks for the info, yeah i was confused about the different types of exhaust manifolds. Got it figured out Sent from my SAMSUNG-SM-J320A using Tapatalk

I'm using a 62t motor with a 61x exhaust system. Could i switch out the 61x exhaust manifold with a 62t?? They look similar, just not sure if it will bolt up to 61x exhaust. Sent from my SAMSUNG-SM-J320A using Tapatalk

Nice, thank you Sent from my SAMSUNG-SM-J320A using Tapatalk

Are the handle pole brackets interchangeable for all rn year models ? I've got a 2000, wondering if a bracket off a 2008 will fit?

The vice option works.. Just did it, use a brass hammer to tap coupler off Sent from my SAMSUNG-SM-J320A using Tapatalk

Looking good! Thanks Chris Sent from my SAMSUNG-SM-J320A using Tapatalk

I went with a few different fillers to experiment with. 3m glass bubbles, q-cells, and sm fairing compound. Thanks for the tips everyone!

Thanks for the info! Sent from my SAMSUNG-SM-J320A using Tapatalk

Need help! What filler is everyone using that's easy to sand and leaves a smooth surface? I've used phenolic microballoons in the past but it seems to leave air bubbles/pockets after curing and sanding.

Impeccable work. Lightened flywheel and bored out nozzle look brand new Sent from my SAMSUNG-SM-J320A using Tapatalk

Great seller, fast shipping! Helping me piece together first superjet build! Sent from my SAMSUNG-SM-J320A using Tapatalk

1 Rode a friends- 4 2- Rode nose high, did plane out took a little longer. Still had good handling, pretty squirrelly fun, might be tough to learn in surf 3- 165 4- Imo i think a - 2 would be perfect Sent from my SAMSUNG-SM-J320A using Tapatalk

Ok i see, thanks Sent from my SAMSUNG-SM-J320A using Tapatalk