Search results

Good afternoon all, I'm looking for replacement aluminum tubes that go inside the KP pole. I see the RRP ones on blowsion are around $50 each... anyone know of a vendor that has ones that aren't RRP? Maybe a tad cheaper?

Nope no lanyard. I also take my AG battery out after every ride and did the same before I put it in storage for winter. No power was going to the unit for about 4 months.

Got the new unit from JetManiac today. Put her in and she's perfect now. It was absolutely the Zeel unit.

I purchased a new Zeel unit from JetManiac. Will update once I receive it and test.

I removed the extension cable from the Zeel unit and had the same results. There is spark when I crank the motor using the start button and the Zeel unit is plugged into my laptop. There is NO spark when I crank the motor using the start button and the Zeel unit is NOT plugged into my laptop.

I am running the extension cable. Are you stating to test the results if they change when I remove the extension cable from the Zeel unit?

I purchased mine less than 2 years ago as well.

Crap, that's the worst news I've heard this year :( This is exactly what I'm seeing. The RPM's read when I crank, the test spark fires loud and bright. Darnit I really didn't want to have to purchase a whole new zeel unit.

I can visually see and audibly hear the spark. It's quite loud and bright :)

Confirmed with my volt meter that I'm getting power to the Zeel. For giggles I disconnected the fuse leading to the zeel power and tried to "test" spark through the software. It wont fire when there's no power to the zeel.

I'm having some spark issues after re-doing wiring on my 760 Zeel setup in my 1107. The motor cranks without issues. I can see spark when I test it using the software "test" button I can see spark if I crank it with the programmer plugged in via USB to my laptop... But if I unplug the laptop...

For visibility. I live in northern Arizona. I ride in 50 degree water and during storage it gets down to 10 degree air temp. I also ride in havasu where air temp is in the 100's. Your initial theory where this occurs on big temperature swings fits my story.

Hey all, I was doing a leak down test today after installing some new crank seals. I noticed the pressure would drop pretty fast so I knew I had a leak somewhere post installation. Found this spot with a soap/water spray. Motor is an ET1107 These are 62t cases that have been ported and have...

I'm not sure why but mine doesn't, and I remember reading on here that other had the same experience. Not sure what I've done wrong... Anyway.. Does anyone make an aftermarket flywheel cover that accepts the pickup from the 760 electronics? I'd love some colors to match the rest of my build.

The bottom right bolt on the flywheel cover doesn't line up. I was assuming this was everyone's experience when attaching a 760 front cover to a 701 crankcase?

Yikes, I'm dumb. I meant the 760 electronics.

Is anyone aware of a flywheel cover that will fit the 701 crankcase that accepts the 64x stator that attaches to the flywheel cover? I hate my old cover that doesn't align just right with the 701 crank case currently used with my Zeel setup.

I run dual 46's at Havasu which is about 500ft elevation. 120 main 1 turn out 130 pilot 3/4 out 21 psi pop off 110 octane Oem 150 pump Pf pipe wet Zeeltronic TL

*drools* I want that.

I'm dumb and was trying to install the cable backwards. If anyone has this issue, simply try inserting the other end of the cable in first. That being said, I really love the HD steering cable. It's beefy and has a very smooth throw to it. Would purchase again.