Search results

Small FX1 Hull and Big Obtuse chambers not a problem! Good Luck!

Looking Real Good Joe! Ive been drooling over the engine setup you got. Id choose the speedwerx since you have one.. however If all else fails i think the FPP Limited is the sensible choice given reliabilty and lowend brappp. not to mention the potential maintenece and coupler issues of the dry...

They're selling their molds on eBay now...

Holy orange hoses batman! What are you running for a hood seal?

this could be a multitude of things. First make sure the battery is charge with enough juice to actually crank the engine. Then verify that the crank shaft spins, perhaps it is stuck, pull a spark plug or both and insp for water and try to rotate dshaft by hand. Check the drive pump and make...

Is the shaft still crooked while in the bearing housing with the engine out of the hull? Does the shaft have loose slop in the bearing like it may not fit snug inside the mid shaft bearing possibly causing off center? You want the pump shoe flush across the bottom of the hull, glass work takes...

Danky, have you looked at wave hogs pump install thread, had some close up shots of the shoe area work, also JD aka specialfx might be able to chime in, make sure your 6304 bearing that was pressed into the yami housing is straight and that the mid shaft housing is flush on the bulkhead wall. It...

701 Protec manifold stock 61x gasket..

Are you trying to use a 650 gasket onto a 701 cylinder as well as a 650 manifold on to a 701 cylinder, if so match the gasket to the cylinder then set the gasket on the manifold, scribe and then widen as needed. Or just get a 701 gasket and use as reference

more than likely the impeller is bent and trashed. caviataion and loss of thrust is a dead giveaway. Noises too? That probably means the machined ring ( wear ring) section is damaged too. bearings and shaft may be damaged too. This can all be fixed, however her best bet may be to find you a...

Super dope, love one off original artwork ! Cool azz build!

Pm Chris aka jetmaniac on here. His parts list is in my sig down below, he's crazy fast and informative. Good luck

Jetmaniac duhh. Don't know if he has the newer restricter though... Ask him, I'll start.. " hey Chris, do you have a Jetworks valve and some gaskets for this guy?"

Better than compared to what? a BOB FOR FLATWATER FREESTYLE? -Then probably not. But a very nice nimble boat chasing wake jumping toy that you can flick around like a stick with a pump mod and be less expensive then a BOB..Then yes! Great Boat in the Surf and mild chop to play around on. Ask...

His wallet, welcome to the club..

cheapest I have seen was 700 bucks and mid-way about 1800-3500 ( That actually sell ) Not the way overpriced ones that are still unsold by people asking too much. Good Luck!

Polaris Octane, big power big foot tray most forgiving and easy learning curve! Octane Love!