Search results

Sorry for the lat response, Ski has sold SOLD

Thanks man

Yes it is

I am , you will need to get a freight quote.

Tiger Craft v2 aqua bot with a 10 mil 1000cc Dasa. Novi 48s, TNT Lay down pipe and water box, blowsion light weight handle pole, Rrp ovoid steering Rrp riser bars Rrp Carbon chin pad Msd enhancer Rrp lightened flywheel(3* advanced) Yamasaki coil Billet couplers Limited slip tank 148 mag -4...

Tiger Craft view to aqua bot with a 10 mil 1000cc Dasa. Novi 48s, TNT Lay down pipe and water box, blowsion light weight handle pole, Rrp ovoid steering Rrp riser bars Rrp Carbon chin pad Msd enhancer Rrp lightened flywheel(3* advanced) Yamasaki coil Billet couplers Limited slip tank 148...

just ordered a crank and some other stuff from jet maniac and just like always, best service in the industry and the parts are top notch,thanks to the maniac for making this stuff super easy,don't check prices any where else, just hit up jet maniac and thats as good as it gets…..

brando and bills skis gone,is there something i should know about,do i need to sell my foot rocket? my pole is set at 35" from the pole bolt to the steering hole and it feels great,i cut 2" off my tubes and adjusted it as short as it would go.

check these out #1010

i said a bang,bang, a bangidy bang, bang,bang,bangity bang

hahahahahahahahahahahahahahahaha!

yup,like the last flat spin he dose,no set up or nothin,just motor,super sic.

or just dont do any fist pumps at all:Banane19:

my buddies drive line snapped in his rickter and it was lined up perfectly,he just did a roll and when he hit the water it snapped.

thank you,i will go check now.

where do you get the rubber to replace it?

thanks man,i actually think i might get a versa plug and ditch the scupper altogether,i was just reading about this topic and the votes are in : versa plug=good scupper = bad

i have a 24/7 scupper installed on my ski and the rubber flapper is bad and i can not find a replacement for it,can i take the whole scupper cover off and replace it with an rrp scupper or what , any suggestions would be helpful,i am thinking i will just glue it shut and wire my bilge to run...

pm'ed

i had them backwards when i installed my msd and it would not crank over until i switched them the right way.