Search results

x2 great customer service.

bump for humps.

not sure of the porting dimension,i dident port it,i was just told it was mid to heavy.

im on a 750 sx,medium-heavy porting,rd o-ring head 195lb in each hole,duel cdk40's,factory pipe limited with flow control valve,rd timing advance plate,and i would like a prop that is good for rec riding and will give me the bottom end punch i need for free style,but if i had to go one way or...

sweet vid,did you get any of the rolls the guys where doing.

not using stainless bolts on my ride plate.

i was wonering what the advantage of using the pump spacer wedge is,do i need it or can i run without it.

http://sacramento.craigslist.org/boa/2639179408.html get some.

???

i just bought a new motor and i am not sure what octane to run for the break-in,also what 2-cycle oil isthe best to use,here is the post on the motor i bought.please help if you can. http://www.pwctoday.com/f149/built-750-motor-fresh-ready-race-342534.html

thanx vita and kev.

what do the lines connect to.

new motor and factory limited pipe and i dont know where these hoses coming from the ebox go,please help if you can.

thanks jp36.

thank you whitca,it worked out perfect when i angled it to the right a little bit,thank god for good help.

i am installing a pump primer on my 750 and i put pump primer nipples on both carbs,is this necessary or do you only need to prime one carb,i put nipples on both carbs because i was afraid of waring out the cylinders unevenly on primed cold starts,was this the correct way or is it overkill,thanks.

i am putting a x2 trim set up on my 750 sx and i need a tube through my hull to run my cable so i dont have to use my stock syphon bilge,my question is,if i drill a hole strait through the hull directly above the 2 factory tubes(bilge and water intake nipples) will i run into any of the stock...

i just put a big pin motor in 750 sx and i went from single carb to dual carb and the linkage on the new twin carb is going the wrong way,so i can not use the stock throttle cable mounting bracket,is it possible to change the linkage pin with one that has the right linkage direction and if so...

just want to know what other trim systems will bolt up to my 750sx other than the x2 setup,and if i put a trim on will it effect my every day riding,thanks to all.

i striped my ski all the way down to the fiber glass(the entire hull),and on the bottom of the hull i dont know if i should jel-coat it or paint with multiple layers of clear,also i wasent sure if i would have to get a new tip for my paint gun to spray the gel coat,all help would be greatly...