Evening
Has anyone got a picture of the SXR crank case (top half) where the starter mounts?? I have a bit of an
issue with my mounting point and think some metal work might be missing.
Be really helpful if somebody could post a pic for me, Google turned up nothing.
Si
I run an AC SJ pole on my SXR - as younalready said it throws the cable a different direction so you need the Blowsion bracket (although we managed to fabricate our own) the quick steer won't fit as far as I know and you will need to run an upside down SJ system.
Once fitted it all looks very...
Afternoon
Just wondered if someone could post the profile dimensions of SXR hood seal??
I need a replacement but not going Kwak as serious ££££ over here so found a guy that makes seals of all shapes and sizes. The seal is still on the hood so I only need the ski part around the engine bay...
Will depend what pipe he is running as to whether there will be enough room to slide it back, also by sliding it back it may allow you access to the tank but if it has to come out I doubt there would be enough room.
Worth a shot though.
Si
Having just stripped my SXR for rebuild I can tell you the engine needs to come out to get the tank out, there's not even enough space to unbolt the engine from plate and slide back.
Unfortunately the lot has to come out.
Not heard of tank cracking there before?!?
Si
Does anyone have a photo of the cuts you need to make in rim of engine compartment I order to fit the engine with dry pipe already attached??
I did mark it up before paint but the got covered when it was sprayed up!
Cheers
Si
Just done the same with mine as when I removed the rail caps during my strip down they broke. Filled holes, glassed the ridges smooth and will be fitting undermpad before turfing up and over the top.
Si
Thanks bud that's excellent helps big time!!! Out of interest is the rear underside of your ski slanted?? Where your two outlets come out the rear they look like they are on an angle?
Si
Afternoon
Just wondered if anyone has any pictures of a trimmed rear bond rail on an SXR?? It has been suggested that before I do my hydro turf I should trim the rear bond rail and corners to reduce the 'scoop' effect.
I wondered if anyone had done it and could tell me their findings and...
Excellent although not sure about a double lol!!! Let you know how it goes - just a good wave, handful of throttle and look backwards I understand?!? And no matter what happens hold onto the ski to avoid certain death!!
Si
Will a stock SXR flip in the surf, if not what mods are needed??
My ski has footholds, pipe, side exit exhaust, d cut ride plate, lightened hull and hood - figured if a stock ski could do it then I should be fine!!!
Have a kind of bet with a buddy who rides a SN jet and I want to beat him...
Thanks guys - I think it's pretty clear that you need to stay in cotanct with the ski and suck up the landing, it's just that commitment when your upside down!!!!!
Air time - that picture is scary man, you were a lucky guy by the looks of it!
Si
Is it better to hang onto the ski or try and push it away from you?? Been watching a few YouTube vids and seen both, just wondered what the advice was out in the surf?
It's a big old thing to land on you either way!!
Si
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.