Search results

I use a Honda aquatrax turbo. I only used this model because I already had it. It’s actually good for fly boarding because it’s not terrible on gas and has enough power for flips. I have a dual impeller. Dual impeller is a really needed on any ski used for flyboarding. Other wise you will...

I have a Flyboard set up. I have a lot of experience. Zapata is still in production, well at the least there is product availability now. Let me know if you have any questions. I recommend David at Atlantic Flyboard for sales.

My friend does boat transport from fl to ca often. Big boats. Easily throw a ski in back of truck

$535, full case of Pabst . No grandma date

Picked her up yesterday. New starter, she’s running. I’ll probably take it out tomorrow for a break in. He said it was at 180 psi…. Photos tomorrow of engine bay. I want too order some bars, grips, hood seal maybe matts. I’m excited too ride again. I have an sxi 750 that needs some love too.

I bought it, described as running well. Put in the water and the carbs needed gone through. Then it had an air leak somewhere. It went off too the side for a while. I’ve been busy but I have someone taking good care of it now. Maybe there was some water in the bottom of the hull when it sat...

It was sbt pistons .5mm over 62t top end. 62t bottom Should I use the 61x or 62t head gasket? Are they the same? If I wanted too bring the head somewhere local and get machined, what are the specs? Pump gas safe. I asked XScream (I’m local/Clearwater fl) but they said there too busy for that.

I did not see a spacer. It’s been a while since I pulled one of these apart. Your right it does look like oem. My friend was saying pork chop was oem.

I bought a superjet from a guy a while ago. Put it in the water and it was running bad. Rebuilt the carbs with oem stuff. Ran much better. There was a run away at idle out of the water. Then it seemed fine. Runs good in the water but idle is funky. I think it’s the crank seals. I dropped it...

Photos attached

I have not been riding or wrenching in a while. I picked up a 2007 super jet, first time out it was very lean at high rpm. Cutting out. I pulled the carbs off. The high and low speed needles were blocked off. I took them to a quality independent shop that works on two strokes. He drilled them...

Can I rent it for a month? Haha

Any interest is selling me that pipe? I can give you my stock one

How much for the one that does not run

There still open. There phone is just down

Skat Trak is still in bussiness right? I just shipped them an impeller but today their phone number seems to be inoperable Thanks

When you rebuilt the carbs, did you change the needle and seats?

Te. I might still make the run with you and then sell the part at cost. After he spends time making his.

I have found out there is actually a company who just made a run of these. There waiting to be anodized. I wonder if he just stole my idea and the three weeks are to make them and anodize them. Whatever, I can buy it from him for $100. Save me the hassle of trying to sell 20 of them...

Photos of mine