SkiDiggity
formerly kawirider142
The quality of these hulls is just unreal. The inside looks better than most of the rickters I have seen lately. Very cool look and can't wait to see the final product.
2016 Phantom Island Tribal Build
- Thread starter tnt01
- Start date
- Location
- Spokane,wa
Can say much about any others hull,but what i can say they are very clean hull and the mounting point for the midshaft and pump was dead on.I felt like I was installing my part back on a stock superjet....lol....
Last edited:
It will all align better than a stock one
- Location
- Spokane,wa
While I am waiting for some parts to come in,It gave me time to register the hull and my registration and my title will be under phantom....yeah baby.....
Last edited:
- Location
- Oroville, CA
Congrats man. Glad your already building. Graphics look great. Welcome to the family!
#phantomgang
#phantomgang
- Location
- Spokane,wa
Thanks hopefully it will be ready for spring break..before that I am hoping I get to test ride the ski before we head back to sac
Yes cold fusion ebox mount will work just put it a little to the left if your standing in front of the ski because of bpipe head pipe
- Location
- Spokane,wa
Thanks miah,just wondering if u got your phantom done.I was reading your build thread.it look awesome
- Location
- Spokane,wa
Well it look like my parts are on it way,chris(JetManiac)is good and never let me down
I've still got to do a few things work has been crazy, still need to finish turf, put my wrap on, and hook up water/fuel lines gonna try to finish this weekend.
- Location
- Spokane,wa
- Location
- Spokane,wa
Nothing exciting,got my 500 bilge pump and e-box mount thank Jetmaniac,just order few more parts to complete the build,then It should be non stop to the end....
And then the fun part, tuning
- Location
- Spokane,wa
No tuning in this ski...everything is tune already to jm spec and the motor run great...
Yup everything is coming off my existing sj hull...unless my motor will need a little tuning just cause I move my set up to a lighter hull but I doubt it....it should be good
There is always a little more to get or I'm just impossible to satisfy lol
- Location
- Spokane,wa
- Location
- Spokane,wa
One less hole on my hull I went and tap and die my handlepole for my hood strap
Seal up the trim pipe with silicone and heat sink to clean it up and epoxy my bilge pump base down
Today install my e-box mount and put back the engine mount and the rubber strap mounts
Seal up the trim pipe with silicone and heat sink to clean it up and epoxy my bilge pump base down
Today install my e-box mount and put back the engine mount and the rubber strap mounts
- Location
- Spokane,wa
Got a little more done today... drill out the hole for the bilge switch,primer,front tie down and e-box mount
And turf my limited slip tank
And turf my limited slip tank
- Location
- Spokane,wa
It suck but I had to do it,rough up everything that going to get turf
