- Location
- Nova Scotia, Canada
I bought a 44mm Mikuni carb for a 650sx with Factory pipe. Unfortunately I didn't know there were different kinds of 44mm Mikunis and I ended up with the less common 3-hole model off a 6m6. I even sent it to JSS for some TLC before I found out. So I'd like to use this carb if I can.
I assume that all the 650sx jetting advice I see online is for the 4-hole model.
So if someone has this jetting in a 4-hole carb......
high 130
low 100
2.3 needle and seat
65 gram spring pop off at 15 psi
high 1.0
low 1.0
... what would be the equivalent jetting in a 3-hole carb.
I will go through the whole jetting process but I'd like to start out in the ballpark if possible.
I assume that all the 650sx jetting advice I see online is for the 4-hole model.
So if someone has this jetting in a 4-hole carb......
high 130
low 100
2.3 needle and seat
65 gram spring pop off at 15 psi
high 1.0
low 1.0
... what would be the equivalent jetting in a 3-hole carb.
I will go through the whole jetting process but I'd like to start out in the ballpark if possible.