3D wins the standup class at the Mark Hahn???

[SUPERJET-113]

I thought there was a limit on the width of the hull for the ski class too???

There is:

Rule 5.2.2
Watercraft competing in the Ski Division must conform to the following criteria:
1) Dry weight must be greater than 102kg (225 lb.) for 550cc classes;
2) Dry weight must be greater than 114kg (260 lb.) for 650cc and 800cc classes;
3) Hull length cannot exceed 304.8cm (120 in.);
4) Hull width must be between 50.8cm (20 in.) and 76.2cm (30 in.).

A 3-D is 44 inches wide!!!
For comparison, a SX-R is 28.7 inches wide.

 

[accbr]

There is:

Rule 5.2.2
Watercraft competing in the Ski Division must conform to the following criteria:
1) Dry weight must be greater than 102kg (225 lb.) for 550cc classes;
2) Dry weight must be greater than 114kg (260 lb.) for 650cc and 800cc classes;
3) Hull length cannot exceed 304.8cm (120 in.);
4) Hull width must be between 50.8cm (20 in.) and 76.2cm (30 in.).

A 3-D is 44 inches wide!!!
For comparison, a SX-R is 28.7 inches wide.

I finally found that in the other thread. That's IJSBA rules, and from what I read in the other thread the APBA rules allow for 38" wide in ski class????? The 3D is still too big for either one. The 951cc motor would make a difference too.

 

[SUPERJET-113]

Ya, the 951 model weighs 610 lbs!!!:bigeyes:

 

[SeaLion]

Looks like they finally got it right and took the 3-D out of the stand up class. Here are the results by class http://www.apbaracing.com/070228_results_hahn_class.pdf

 

[duvers]

Looks like they finally got it right and took the 3-D out of the stand up class. Here are the results by class http://www.apbaracing.com/070228_results_hahn_class.pdf

I guess it's better late than never, but too bad for the folks who didn't have their accomplishments reflected at the awards ceremony.