Anyone Fit a Blaster Mod Chamber in a SJ?

[jpswift1]

I thought I remembered seeing this done by someone a while back, but does anyone know how to fit a Blaster Factory B Pipe with a Mod chamber in a Superjet or other aftermarket hull set up like a Superjet? I think there is clearance, but the outlet of the chamber on the Blaster Mod pipe comes out in a different location. Any help/advice would be appreciated.

 

[waxhead]

Use an sxr chamber. They are easier to fit and you have the out let headed in the right direction. Just a bit of hammering and you are done

 

[bkspeedwerks]

Rad Dudes C4 Chamber Kit | Rad Dudes Freestyle

C4 Chamber Kit for SuperJet, Rickter, or other aftermarket Hulls.**Chamber Clearancing may be required

www.raddudesfi.com

i believe this kit will work with the b1 chamber. i have new one sitting around from a project i never used id sell.

 

[jpswift1]

Rad Dudes C4 Chamber Kit | Rad Dudes Freestyle

C4 Chamber Kit for SuperJet, Rickter, or other aftermarket Hulls.**Chamber Clearancing may be required

www.raddudesfi.com

i believe this kit will work with the b1 chamber. i have new one sitting around from a project i never used id sell.

I think that's what I need. I'm looking to see if I can fit it in a Tigercraft Viper. Can you PM me with what you have to have for it? Thank you.

 

[fastgtfairlane]

You can also use the stock sj stinger to waterbox hose with a bushing on the stinger. I have a tnt ss chamber that is very similar to the blaster mod. You'll need to slightly massage the chamber where it rides against the hull about 2 inches from the coupler ring. I purchased the silicone hose and aluminum pipe from Amazon to connect the pipe to the waterbox. Total cost was around 70 bucks.

 

[subnsxr]

Superjet Mod chamber fits good in a SJ.

 

[waxhead]

Superjet Mod chamber fits good in a SJ.

The sad thing is thats one of the lowest performing chambers out there. the only ones worse are the 650 superjet and the polaris octane