h'yuh! hopefully ill have it in the water by tomorrow. just finished all of the electrical systems. gotta mount the seat base and cushion, connect the batteries and run the fuel lines/selector valves.
whute!
whute!
b piped 760 boston whaler - DONE!!!
- Thread starter sflsurfrider
- Start date
- Status
Kennay
Squarenose for the _____
- Location
- Myrtle Beach, SC
What was it's prior top speed Charlie?
- Location
- s florida
WaveDemon
Not Dead - Notable Member
- Location
- Hell, Florida
you should one up the ultra guy and bring the whaler to daytona.
i just took it for a test ride. the torque is WOW. i need to tweek the carbs. its already better than ever (and yours). :wavey: its no quieter though. lolz.
kennay, top speed was around 35ish.
i think i could one up him and have more fun by bringing a monkey-can-do-it vinyl-graphic'd jetmate.
....but only cause its a kawi... like an ultra 150.
uke:Attachments
Last edited:
green is for puke!
(see post 166)
(see post 166)
ewpps... a blaster mod chamber NEEDS a pisser when running single cooling.... DOH!
Rickster
Matakana Menace
- Location
- Bay of Plenty, NZ
What the???? Holy!!!!!
yup, i remembered that the stinger on a blaster mod is restricted, unlike an SJ chamber. oh well. :dunno:
time to ride! hows the square?
Rickster
Matakana Menace
- Location
- Bay of Plenty, NZ
The SN is good, but the hooker is spinning out too much, so will change the bored protech nozzle with a stock bored nozzle and see how it performs....
Bummer about Yaneve's Mum...
:17:
whats the diameter of the bored protec vs the bored stocker?
Rickster
Matakana Menace
- Location
- Bay of Plenty, NZ
Same diameter nozzle 85mm BUT the protect has more volume in the pump cavity...
Going to try a swap, then look at a few other things....
:shrug:
maybe its not steep enough?
dave made my 10-16 for my bigbore. my 701 doesnt spin it out, but i wonder if itll spin when i put my bigbore in... :dunno:
dave made my 10-16 for my bigbore. my 701 doesnt spin it out, but i wonder if itll spin when i put my bigbore in... :dunno:
Rickster
Matakana Menace
- Location
- Bay of Plenty, NZ
The only thing I can think of is that the protec nozzle does not have internal veins, which would allow for less resistance, hence more flow...
the nozzle is easy to switch out, so I will start with that and see where we land...
the nozzle is easy to switch out, so I will start with that and see where we land...
whurd
- Location
- Houston/Galveston
You should of contracted that out to someone that can tune carbs.
- Location
- s florida
ouch!!:theyareontome:
- Status