Hi everyone. I just moved from new jersey to st petersburg fl. Sold my ktm supermoto for a blaster but it turns out it has a bad wrist pin bearing and I just don't trust the crank (it sat for a while, half taken apart by the previous owner) The guy gave me his spare 62t/61x motor but its also taken apart. I have a ring set and top end gasket kit for the 61x that was in the ski but want to build the spare as it has a brand new hot rods crank but badly scored piston... Can I use the good pistons and cylinders from the beat 61x motor and the gasket set to get this 62t/61x together? I know there are a lot of other variables there but I'm just trying to piece one motor back together out of the 2.
I would also love to know if there are any other blaster guys here in st petersburg fl area that I could get some help from? I just don't know enough about these motors to start winging it. I can pay in beer and laughs for any help. I just don't know where to start with this basket case of a blaster... There are days I wish I kept the ktm.... Lots of them...
I would also love to know if there are any other blaster guys here in st petersburg fl area that I could get some help from? I just don't know enough about these motors to start winging it. I can pay in beer and laughs for any help. I just don't know where to start with this basket case of a blaster... There are days I wish I kept the ktm.... Lots of them...
