SXR Building the best SX-R race engine! Why not DASA?

[Deyanov]

@Mentzel would you pls give me your whatsapp or viber to ask you some questions. I still have problems to set my jet ski and summer end is really close.

 

[Mentzel]

Hi Teodor

I’ll try to dig out the diagram
this week.

 

[fastgtfairlane]

@Deyanov your cylinder head is on backwards, the water outlets should be on the carb side of the engine, not the exhaust side.

 

[Octane_114]

I ran 920 with a pfp exhaust in a bullett gen2 x2.

My water routing: two 1/2inch lines in, one to rear cylinder, I used a splitter and ran a line to front cylinder.

Second line I ran to exhaust.

I started with four lines out of the head, I also first ran a factory pipe exhaust too. I believe I ended up running three lines out/overboard and one off the pipe.

Did y’all use the jetworks fcv?

 

[Octane_114]

I'm running an "a" cyl with a 6 mm small pin stroker crank. Fully ported with total loss and custom mag pump aside from world finals stuff there isn't any triples that can beat my ski to the first turn. It hails butt and is super reliable. Did I mention it revs 8500 rpm in the water

What crank are you using?