Freestyle Bun hull build (maxx hull)

K

kea05

Location
Foxboro
Tell us then, that will turn. Or use Maxx pipe, NYNJA pipe (am not sure), BUN pipe. 1100-1200...do not know yet. I beg Сrankvorks make the crankshaft +16 for my crankcase.
 
Y

yz125514

No found a used GP1200 complete mid shaft/housing. I'm sure it will need some modification but I will figure that out when it gets here.
 
stefan

stefan

Location
denmark
Well finaly and update ski is all together and on the water still some tuning too doo, but it working now hade some trouble with my TL system but it seemes good now. The pipe was a Big problem small waterbox helpede but at the end wee hade too take a pize out off it all is good now. The ride is realy nice for a small hull its soo stabil doo too the with off the hull, it turns a lot faster then anything i have tryede and semi carvs when coming back too the setup wake. I have not tryede any trick yet (Way too mush power) but coming Down from jumps it just lands and you move on from ther, one time my finger slippede off the gas leaver but hade enough time too recover before ski whent under. Cons a the footholds they a just too small for size 12 i have 20 mm padding on bottom and nothing on top, and dont feel locked in will try with Heel stoppers and straps but think new holds will bee done in the Winther. And the scupper that comes with the hull is junk it goes both ways, new one is ordered but all in all for 4000 US incl pump it realy nice hull
 
You must log in or register to reply here.
Top Bottom