Crab's SJ makeover, finally under progress.

Crab

thanks darin...noswad!
Location
Seattle
Pole, hood, ratchet straps, nosepiece, hood hooks, backing plate all installed. Pumps in just waiting for parts to rebuild the midshaft and also need orings for the head. After that it really just needs some turf.
 

Crab

thanks darin...noswad!
Location
Seattle
Motor is in with the pipe on, will hook everything up internal tomorrow and perhaps turf on Sunday.:bananalama:
 

Crab

thanks darin...noswad!
Location
Seattle
99 % done inside, a few things to do later (minor). Going to try the MSD digital water injection with a toggle switch on the pole, so I can evaluate how well it really works. Also need to install a fuel reserve switch for those long Sunday river rides, nice to know when your getting low. Having some trouble locating where I put my primer, and need new lines for that. Turf tomorrow:aargh4:
 

Attachments

  • 101_5712.jpg
    101_5712.jpg
    77.1 KB · Views: 89
Last edited:

Crab

thanks darin...noswad!
Location
Seattle
:Banane13:90% turf done, just the hood cavity and rails left, but screw it I can't wait it goes in the water tommorow.:beerchug:(pics tomorrow)
 

Motorheads5

Livin the generation gap
Location
ketchikan alaska
:Banane13:90% turf done, just the hood cavity and rails left, but screw it I can't wait it goes in the water tommorow.:beerchug:(pics tomorrow)
wait a minute I read the whole damm thread payed attention to the date here we are and we don't even get to see it :nono:
very nice work hope it run's like a rabbid biotch for ya
 

Crab

thanks darin...noswad!
Location
Seattle
wait a minute I read the whole damm thread payed attention to the date here we are and we don't even get to see it :nono:
very nice work hope it run's like a rabbid biotch for ya
I'm going to unveil it tommorrow at the river launch, with some pics. I got the hood turfed, but not the rails. My wife is leaving in the morning for Anchortown, so can't do much more today.
 

Crab

thanks darin...noswad!
Location
Seattle
A couple shots from the shop. Extra wide tray and modded Rev's. 8mm underpad on tray, sides, top. However its scalloped out for the toes for more room.
 

Attachments

  • 101_5716.jpg
    101_5716.jpg
    89.6 KB · Views: 82
  • 101_5717.jpg
    101_5717.jpg
    79.3 KB · Views: 67
  • 101_5718.jpg
    101_5718.jpg
    77.6 KB · Views: 54
Last edited:
Top Bottom