ckjetski
BRAAAAP
- Location
- San Clemente/Santa Barbara CA
I have been testing/running the new tau ceti/blowsion air filter for 2-3 months and i have not had any problems with them and i have really put a good beating on them. my 2cents
damn blowsion air filters
- Thread starter st.clair.jetski
- Start date
Even if you get the cap to stick on with the tauceti's chances are the caps will end up breaking apart. To salvage what would otherwise be a good filter...remove the cap, clean the surface of the filter and stick some turf on there. Once you trim it to suit, it looks good, doesn't let in water and is vibration resistant. We've run them like this for quite a while now and no problems yet.
snowxr
V watch your daughters V
- Location
- Waterford, MI
Bulletproof?!? If someone is shooting at your carbs you have more serious problems to deal with.
- Location
- sunbury ,ohio
I Dont like K&N marine series either, this cost me a topend . I had this one rip due to my fault , however the other one ripped a couple rides later due to quality , Pro series... IDK, I hope they are better . I just went back to oem Fa's and my worries are over .
Big Kahuna
Administrator
- Location
- Tuscaloosa, AL
They are going to all fail at some point, just like your slippy or jetpilot riding boots. I have found the K&N to hold up longer. Now the old metal top K&N's. Junk
NVJAY775
My home away from home.
- Location
- Gardnerville, Nevada, United States
The chick dig factor may not be there, but the stock fa's work like a peach.
the WaTeRhAwK
fryin' up a/m electrics..
- Location
- okc
you can make your own pre-filters with monofilament screen printing cloth and silicone spray surface lubricant.
- Location
- baldwin ny
lol i though i was the only one that did this!!! works great!!!