The M10 bolts Yamaha uses are 1.25 pitch, which is unusual.
But the smaller bolts have standard pitches.
Thanks Cattledog, perfect.
Well you can buy alternate bolts and do it that way but the instructions say to tap four 5mm holes that the steering base screws into. you then put the turn plate on that and then screw the turn plate down using the stock turn plate bolts
Thanks cattledog
So the two center bolts for the b pipe manifold are too long. Anyone have any tips to shorten these? I don't have any nuts to put on the bolts so I can rethread the end of the bolt after I cut it. Is it difficult to file these bolts to get the threading back?
Don't have everything hooked up yet, just got the motor back in, hooked up most of the fuel, haven't put together my bilge mess which is most of those wires all over the place. So it's a bit of a mess. I will be cleaning up the hoses and wires when I get it ready for riding.
Thanks for the input man.
And yah, spring couldn't come quick enough now haha